4/12/2024 0 Comments Soldering alligator clipsQUALITY: The heavy duty cast iron base keeps the unit upright and stable and provides a secure and firm hold that keeps objects steady while working on or soldering components. ![]() Dual Alligator Spring Clamps Hold Work piece Steady. I probably should have left it at that but my mind is thinking "you didn't use proper soldering technique and just created a cold solder joint and you better reheat the joint and add some solder", so I did but in the process burned the green and while the joint feels solid it looks worse than before the reheat. 2-1/2-Inch, 2X Magnifying Glass for Precision Work without Eyestrain. (Solder-less screw-on plugs are available, but in my experience the soldered variety are much more durable. Meanwhile, AudioTrendsTV has a helpful video showing how to solder a banana plug. The "stick" looked pretty good and when I pulled on the wire it felt solid. Mueller even has a helpful video showing three different ways to attach an alligator clip to a wire. Clips ( See Clips, Cable ) Cable Hangers ( See Hangers, Cable ) Cable Racks. Large alligator clips with plastic finger grips and a screw for connection. ![]() In hindsight this was probably a through hole joint as there was also a blob on the other side of the board and if I would have desoldered/cleaned the joint entirely I would have had a through hole to attach the wire to before re solder eliminating the need for a third hand but I am I novice and wasn't sure.Īnyway, I couldn't find a good place to clip the wire because nothing was stationary and there was too much movement going on so I stuck it using the tin tin tin technique. soldering, namely: making two clip leads, putting alligator clips on the multimeter leads, and putting alligator clips on the wall transformer leads. Anchors, Guy The letter with accompanying number. Feed wire through the barrel of clip then through the first hole by the screw. You can tin the copper if you like but its not necessary. ![]() Strip off the insulation approximately a half inch (13mm) to an inch (25mm) on the wire. I stripped the wire and wicked most of the solder blob of the board. soldering flux and wire, alligator clips, a fibreglass scratch pen and Blu-Tack sticky adhesive pads. Really no need to crimp these types of alligator clips. or smaller in tight quarters on top of the Playfield with no good way to stabilize the board because I had take the screws out of the board and let it hang by all the other small wires attached to it. Well, I broke a small wire at the joint where is was soldered to a small light circuit board, probably 24 ga. ProTechTrader Solid Copper Alligator Clips (4 Pack) Crocodile Jaw Soldering Heat Sink & DIY Test Clip Wire Connector Rated for 5 Amps (5a) & Up to 12 ga (12awg) Wire Visit the ProTechTrader Store 4.5 325 ratings 799 (2.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |